Versatile: Can be used for fishing, casting, trolling, diving, or anywhere a self-powered high-intensity light source in various colors is required. To make this light facing up off the bottom, or facing down like a bobber, you can attach floats to the light that we include.
High-Intensity: Incredibly bright for its battery capacity at approximately 600 lumens.
Portable: Battery-powered this light runs for 1 hour of run time off a single 3000mah Samsung rechargeable battery. We sell this light with 2 batteries for 2 hours of run time.
Fish Attractant: Lure all sorts of aquatic life to your underwater light. Fish are lured to underwater lights because phytoplankton congregates around them at night to feed after the sun goes down. Our green 520-nanometer single wavelength attracts fish the best.
Depth Rated: Fully submersible up to 500' deep you can cast this light down deep, or even use it as a dive light. You can target fish at specific depths by looking at your fishfinder.
Easy-to-Use: Just plug in the batteries and tighten the expansion plug to make this light fully submersible. Attach to your rod through the cooling hole and drop down to any depth you want.
Portable: Runs off (2) lightweight Samsung commercial-grade 3 amps/hr, 18650 lithium-ion batteries. Other gigging lights on the market require you to carry around a 12V battery, making this incredibly lightweight and easy-to-use. The lighthead only weighs 12 ounces and the PVC shaft weighs 6 ounces. Together it weighs slightly over a pound.
High-Intensity: Puts out 1200 lumens in bright white from a Cree XML L2 LED chip. Even in less than ideal murky water, this light will illuminate a huge area equivalent to 1 of your car headlights on high.
Capacity: About 2 hours of run-time for non-stop flounder gigging. Additional batteries can be purchased if 2 hours isn't long enough for your use.
Multipurpose: Can be used for casting, trolling, or anywhere a high-powered waterproof high-intensity light source is needed.
Fish Attractant: Use this light for nighttime gigging of flounder, frog, shrimp, etc. Fish are attracted to light during the night.
Color: We use bright white because it is proven to be the best for flounder gigging.
Submersible: 40% of light is reflected off the water when using an out of water pool light, Epoxy embedded and designed to last a lifetime in the pool.
High-Intensity: 12 - 3 Watt LEDs for a total of 36 Watts. This light is so much brighter than other lighting options on the market. Each color puts out differing lumen amounts:
Blue: 50 * 12 = 600 lumens
Aqua: 110 * 12 = 1320 lumens
Green: 130 * 12 = 1560 lumens
White: 180 * 12 = 2160 lumens
Easy-to-Install: Just hang the wire loop around the coping of the pool and this light is plug and play.
Energy-Efficient: Replace the costly halogens and lower electrical costs with LEDs.
Color Options: Available in Aqua, Blue, Green, White, Red, and Amber.
Wide Beam Angle: 140° beam angle with water refraction disperses light spread around the pool for even light dispersion.
Easy Install: All you have to do is drill 2 small 1/8" holes in the back of the boat and surface mount the lighthead to the back of the transom. Then run the wires through the holes and connect the positive wire to the positive battery terminal and the negative wire to the negative battery terminal on a 12V battery.
High-Intensity: Incredibly bright and affordable, we by far offer the highest lumen per dollar ratio in the underwater lighting industry for transom lights. Look at the table in the product pictures for more information. Read more below how lumen output is dependent on LED color.
Long-Lasting: Built with high-quality materials, these will last for years of underwater submersion. Built with (40) 3 Watt LEDs totaling 120 Watts, our LEDs last for over 40,000 hours. With proper minimal maintenance, this light will last a lifetime.
Fish Attractant: Lure all sorts of aquatic life right up next to your fishing boat. Green attracts the most fish.
Dual Color Options: Available in dual-color variants, you can choose two colors giving you two colors of LEDs one on each side of the lighthead. You can either blend them or run them separately.
Easy Install: Simply drill 2 small 1/8″ holes in the back of the boat and surface mount the lighthead to the back of the boat transom.
High-Intensity: Incredibly bright and affordable, we offer the highest lumens per dollar ratio in the underwater transom lighting industry. We offer 6 times more lumens for the cost than our closest competitor. Look at the table in the product pictures for more information. Lumen output is dependent on color. Read more below to decide your color.
Long-Lasting: Built with high-quality materials, these will last for years of underwater submersion. Built with (24) 3 Watt LEDs totaling 72 Watts, our LEDs last for over 40,000 hours. With proper minimal maintenance, this light will last a lifetime.
Fish Attractant: All sorts of aquatic life will be drawn to this light. Phytoplankton are attracted to underwater lights at night as a food source. In turn, other members of the food chain will come to feed on the phytoplankton.
Dual Color Options: Available in dual-color variants, we offer two colors of LEDs one on each side of the lighthead. You can either blend them for a 3rd color or run them separately depending on what you want.